Instructions for installing the Automatic Angle Compensator to the conveyor frame and wiring it to the Integrator Box.

Instructions for performing Test Weight, Material Test, Digital, Belt Length, and Zero (from Menu and Keypad) calibration.

Covers scale accessories, integrator specs, scale components, installation, configuration, and troubleshooting.

A guide for installing a magnetic shaft speed sensor on applications where a speed sensor on the belt can't be used.

A block diagram guide for the new Magnetic Speed Sensor for both the Standard Option and RBT Option.

Guide for installing the ROLL-R scale designed for portable crushing, screening equipment, and non CEMA conveyors.

Instructions for using the Setup Wizard and performing Scale Zero, Test Weight, Material Test, and Digital calibration.

Instructions to adjust the speed sensor setting to 100 pulses per revolution in the current and before 2014 Integrators.

Guide for performing a Zero and Material Test Calibration.

Guide for performing a Zero and Test Weight Calibration.